Use my current location OneUp Components EDC Threaded Top Cap Oil Slick
Up to 12 months interest free
OneUp Components EDC Threaded Top Cap is the original, most widely-used and most cost-effective way to store an EDC V2 Tool in your steerer tube. It’s also the world’s lightest headset top cap and the #1 choice for the world’s fastest EWS racers. Get one and never forget tools again. Available in 9 colours: Silver, Red, Orange, Oil Slick, Gold, Green, Blue, Black and Purple.
Tap It In
The magic of EDC Top Cap comes from how it attached to your steerer tube. In order to install the Top Cap, you have to thread the steerer tube of your fork. OneUp Components EDC Tap Kit makes the job quick and easy. You don’t even need to remove your stem.
The Racer’s Choice
Enduro world champions and athletes around the globe choose the EDC Top Cap for their race bikes. It’s light, trustworthy and gives you the most storage options of any in-stem EDC carrier.
Compatibility
The EDC Top Cap is compatible with all 1-1/8" aluminium steerer tubes (even old ones). Note that the EDC steerer plug is required for EDC tool storage and is compatible with most aluminum tapered steerer tubes, but not all.
Incompatible Forks
- Forks with Carbon fiber or Steel Steerers
- All Cannondale Lefty
- Rock Shock 35 Series
- 2022 Fox 38 Performance series
- Giant Overdrive 2
- All Giant Overdrive 2 Forks
- Some Fox 32 and Fox 34 29 Forks
Installation
Installation is easy with the EDC Tap Tool. Please confirm fork compatibility before starting the installation process below.
Full EDC Top Cap Compatibility Details
You need a minimum of 5mm of headset spacer above the stem and the top of your steerer tube should be 1-2mm below the top of this spacer.
Apply a small amount of grease to your newly cut thread and screw in your new EDC top cap.
The Top Cap interface uses a standard cassette lockring tool. You do not need to apply much torque as you are only preloading the bearings. (Your stem pinch bolts are what holds your fork in place). The EDC multitool contains a top cap tightening tool. So even when riding you always have the ability to tighten your headset if need be. Align your stem and tighten your stem bolts to the manufacturers recommended torque.
The final step is to insert the plastic bung/plug into the bottom of your fork. Turn your 8mm hex sideways and use it to push the plug into the fork by pulling the 8mm towards your chest. This piece holds the bottom of the EDC Tool and stops it from rattling. It also keeps dirt out of your fork and has a small drain hole.
| SKU | 1C0414OIL |
|---|---|
| UPC | 005206282194 |
| Season | 2023 |
| Click & Collect | Yes |
| Shipped Nationally | Yes |